Table of Contents
Connect USB-Host-Connector to a Trizeps
Applies to: Trizeps-III, Trizeps-IV(M), Trizeps IV WL, Trizeps-V.
See also: Trizeps USB-Driver
Schematic
Typical connection of USB-Host-Connector
- Place 15K pull-downs near USB-connector.
- For best compatibility with all modules, mount R24 and R29.
- For a cheap solution, where overcurrent-detection is not needed - i.e. when using on-board USB-devices - U10 may be ommited. Though the Trizeps has a weak pull-up on USB_OC1 and USB_OC2 pins, an extra pull-up is recommended. Note that those pull-ups need to be connected to +3,3V and not +5V!
Signals
| Signal-Name | SODIMM-Pin | Remark |
|---|---|---|
| USB_DP1 | 143 | USB-differential Port 1 |
| USB_DM1 | 145 | USB-differential Port 1 |
| USB_DP2 | 139 | USB-differential Port 2 |
| USB_DM2 | 141 | USB-differential Port 2 |
| USB_PEN1 | 129 | USB-Port 1 power enable |
| USB_PEN2 | 127 | USB-Port 2 power enable |
| USB_OC1 | 131 | USB-Port 1 overcurrent-detect |
| USB_OC2 | 133 | USB-Port 2 overcurrent-detect |
(C) 2009 Keith & Koep GmbH. Alle Rechte vorbehalten. Nutzungsbedingungen
(C) 2009 Keith & Koep GmbH. All rights reserved. Terms of Use
(C) 2009 Keith & Koep GmbH. All rights reserved. Terms of Use