Access to information is restricted depending on your login.
Request login-information through our contact form.
Bootloader for PXA168
The 1.1 GHz bootloader will run on Trizeps-VI modules with 1.1 GHz speed-grade.
The 800 MHz bootloader will run on Trizeps-VI modules with 1.1GHz or 800 MHz speed-grade.
View the serial-number-sticker for speed-grade information.
Update
- Put pxa168.nb0 on a SD-Card.
- Insert it into your device and run the bootloader command prompt (Bootloader for Keith & Koep Trizeps Modules):
boot mmc pxa168.nb0
Downloads
Note that there are different Trizeps VI versions. A bootloader generated for A0-processor silicon will not work on the newer B0-silicon!!
Release Notes:
1.1 GHz, 128MB RAM
1.1 GHz, 256MB RAM
800 MHz
- pxa168_800_2012_01_03.nb0 (Do not use on 256MB RAM modules!)
Frequency can be changed in the bootloader menu. If you want to change to 1.1GHz, enter the bootloader and type:
:) :)menu -------------------------------------------------------------------------------- Eboot Main Menu -------------------------------------------------------------------------------- [0] IP address: 192.168.80.1 [1] Subnet Mask: 255.255.255.0 ... [P] Power Management settings [T] Test Menu Selection: P -------------------------------------------------------------------------------- Power Management settings -------------------------------------------------------------------------------- ... [9] Running Operating Point : (800MHz) [A] Minimal Operating Point : (800MHz) [B] Max Operating Point : (800MHz) ... [Q] Quit to Main Menu
Select options 9, A, B to point to the wanted operating-frequency. Afterwards press [Q] and two times [S] ( “Set BSP Configuration” and “Save configuration to FLASH”).
Old Revisions
!!! Do not use on new Trizeps VI modules !!!
800 MHz:
pxa168b0.tft( B0-stepping, 21.09.2010)pxa168a0.tft( A0-stepping, 16.06.2010)
1.2 GHz:
pxa168.rom(A0-stepping, 09.04.2010)
(C) 2009 Keith & Koep GmbH. All rights reserved. Terms of Use